Welcome Lisong industrial technology Co., ltd !

News

How can I install the injection mould of the injection molding machine?

TIME:2021-02-19 Share

The injection machine is a machine that melt plasticize the molding material inside the heating cylinder and inject this into the mold tool to create the molded product by solidifying inside it.

How can I install the injection mould of the injection molding machine?
1. Installation method of injection molding machine with mold positioning ring:
a First press the [OPEN MOULD] key to turn the machine to the highest position, and then press the [SEAT] key to move the seat back into the cylinder to the end.
b Put the mold on the lower mold plate, use the [Adjust mold] button, press the [Mold mold] button to stop the upper mold plate at a certain position (about 15mm) away from the mold, and readjust the position of the mold positioning ring and the center centering hole of the upper mold plate , And then press the [Clamp] key until the upper template is in close contact with the mold.
c Turn off the motor, and then fix the mold with a pressure plate or directly fix it with screws. The mold installation is complete.
d Set the pressure, speed, position and time of mold opening and closing.

Injection molding machine molds

2. Installation method of injection molding machine without mold positioning ring:
a First press the [OPEN MOULD] key to turn the machine to the highest position, and then press the [SEAT] key to move the seat back into the cylinder to the end.
b Place the mold on the lower mold plate, use the [Adjust mold] button, and press the [Mold mold] button to release the upper mold plate at a certain position (about 15mm) from the mold and stop the mold clamping action.
c Press [Seat into] and let go when the spout is about to touch the sprue gate of the mold, and then visually check whether the spout is facing the sprue gate from the front, back, left and right. Adjust the position of the mold to make the two completely coincide. The spout is far away from the gate, and then a piece of thin paper or a little ink is applied to the sprue gate, and then press [Seat] to make the spout contact the mold gate, and finally take out the paper to observe its traces or observe the traces of the ink to confirm. Misalignment, readjust.
d Press the [Seat Back] key to move the seat back to the end. Then press the [Clamping] key to make the upper template close to the mold, turn off the motor, and fix the mold with a pressure plate or screws.
e Set the pressure, speed, position and time of mold opening and closing.

The above is some knowledge about installing injection molds on injection molding machines. If you want to know more about injection molding machines, please leave us a message.

Related News
Related Product
LI SONG Injection Molding Machine-TECHNICAL & SPECIALTY

2020 Star Of Injection Molding Machine Manufacturer!

Please write it
kevin@lisonginc.com
TOP