Welcome Lisong industrial technology Co., ltd !

News

Lazy operation guide for injection manipulator

TIME:2021-04-12 Share

The lazy man's operation guide for injection molding manipulators:
1. Preparation
Make sure that the power source, air pressure source and other power sources are properly connected, and check the pressure of the manipulator air pressure regulator to 0.4mpa-0.6mpa

Two, boot up
Turn on the manipulator power switch to perform the manipulator origin return action. Set each action mode of the manipulator, which is specifically set according to product requirements.

Three, set the parameters
According to the standard parameters on the manipulator fixture, enter the manipulator standby position and gripping position. Then set the mold opening stroke of the injection molding machine according to the parameters on the label.

Four, machine inspection
Inspect whether the clamp screws are loose, whether the holding clamp clip is damaged, whether the cylinder expansion and contraction is normal, whether the air leaks, whether the suction cup is intact, whether the fittings are stuck and other defects.

Five, installation and commissioning
After the fixture is installed OK, observe whether all the fixtures of the fixture are on the same vertical plane. If not, adjust the blocking screw on the connection block to make the fixture on the same vertical plane. Semi-automatically fine-tune the gripping position, after the adjustment is OK, save the parameters. Then set the posture position of the manipulator, the open position on the way, the open position of the product, etc. in sequence.

injection molding manipulators
6. Preliminary settings
Enter the manipulator timer module to make preliminary settings for each action time. And preliminarily set the ejection delay (2s) and back delay (5s) of the ejector pin of the injection molding machine. Fully automatic operation of injection molding machine and manipulator

Seven, operation observation
Please carefully observe the operation of the two equipment in the fully automatic state, and then fine-tune the time of the manipulator and the time of the injection molding machine (thimble ejection delay, thimble back delay, intermediate cycle time, etc.), so that the manipulator can do it The most rapid and stable action response. After the adjustment is completed, fully automatic production is carried out. You can leave after observing 20 molds or more than half an hour and there is no fault alarm.

Related News
Related Product
LI SONG Injection Molding Machine-TECHNICAL & SPECIALTY

2020 Star Of Injection Molding Machine Manufacturer!

Please write it
kevin@lisonginc.com
TOP